Whirlpool WPW10341320 Dual Ice & Water Valve

$63.11

Has (5/16″ Easy Slip Inlet) – (1/4″ & 5/16″ Easy Slip Outlets).

In Stock

Whirlpool WPW10341320 Dual Ice & Water Valve

Has 5/16 inch Quick Connect water inlet port. 1/4 inch & 5/16 inch Quick Connect water outlet ports.
Replaces Part Numbers: W10341320, AP6019939, 1937969, PS11753250, AH11753250, EAP11753250. Used with WPW10238100 single valve.

Installation Instructions

  • Slide refrigerator out enough for you to get behind and work.
  • Disconnect power and turn off water supply to refrigerator.
  • Remove screws off holding the back cover.
  • Remove (2) 1/4″ water valve mounting bracket screws.
  • Pull water valve out of refrigerator cavity.
  • Disconnect each wire harness at each solenoid of valve (Keeping note where each one goes).
  • Cut water tubes close to each port where they connect into old valve (Keeping note where each one goes).
  • Next insert water tubes respectively into ports of new water valve.
  • Attach wire harness leads to their respective solenoid coils.
  • Insert water valve into refrigerator cavity and attach (2) 1/4″ water valve mounting bracket screws.
  • Turn water on and check for leaks.
  • Take a glass & run about a quart of water thru the front dispenser to flush out air that is in the system.
  • When all is good, attach back cover and slide refrigerator back into place.
  • Now it’s all done and ready to make sparkling ice & deliver clean water.

You save approximately $150.00 by doing this repair yourself.

The WPW10341320 Water Valve Is Found For The Following Models.


Additional information

Weight 2 lbs